16 bit ECU to 32 bit Conversion How to

The slots that are open in your picture are supposed to be open at the word have been change or that's what it looks like right after removal from 16 bit I have an 01 and slots you have empty I have full
I seem to have the pin swap correct and the correct 62 bit ecm(an '05)..is my hub correct?..it has a tooth missing from the factory?) Could you please check my recent post with pics. I would really appreciate any advice. I am stuck.
 
The hub seems correct, but it has been years since I did this swap. If you aren't sure of what year rotor /hub you have, try to Google the part number and see if that turns up any info.
 
Hello. The topic is old, but I wanted to upload photos. Power Commaner 5 Autotune for Hayabusa 06 + 16bit ECUs Hayabusa 00 work smoothly according to this schemeI replaced the external pump with an internal pump from Hayabusa 06. All the wiring of the Commaner 5 cables was done with soldering the connections.
IMG_20190609_180047.jpg


IMG_20190609_180107.jpg


DSCN0847.JPG


IMG_20190608_165534.jpg


IMG_20190611_092900.jpg


IMG_20191010_121138.jpg


IMG_20191005_115551.jpg


IMG_20191003_184133.jpg
 
Last edited:
Thanks for posting the 16 to 32 bit swap. I have a 2000 drag Busa with 1397 and pc5. I have been wanting to change to a 32-bit but wasn't sure how to do it. I bought a ECU and a hub and did the pen swap. All parts was $200 on eBay. Your directions were very clear and I followed it to the T . I started the bike and it cranked right up . Oh boy she sounds great. Now waiting to get a remap with the new ECU because I'm sure it is burning to lean now without the pc5 and the built motor. Thanks I couldn't have done it without this post.
 
If you have an '01 you can just plug the 02-07 ecu in and swap the rotor on the crank to the 02-07.
The Crank sensor wires are also swapped for polarity on the 02-07, but I have used them with completely stock orientation with no issues.

John
Hello i have 2001 busa. With this ecu model my bike running or not the ecu is for 2006 model . Have switch to the lights but 06 havent

IMG_20210618_173612.jpg
 
I swapped the an 03 rotor and ecu into my 99 with the pin swap. Fires up and runs good for about 5 -10 minutes and shuts down. Has done it consistently 5 times. Cools down and fires back up.

Any idea why or where I should start diagnostic?

Thx
 
I swapped the an 03 rotor and ecu into my 99 with the pin swap. Fires up and runs good for about 5 -10 minutes and shuts down. Has done it consistently 5 times. Cools down and fires back up.

Any idea why or where I should start diagnostic?

Thx

read my page here to find out where u eventually went wrong.

and what ecu u can use.

i did the swap at my 1st and 2nd ´00 without any issue years ago (twice)
 
Back
Top