1" Reapers Risers + Helio bars

cobravenom39

Registered
I already have the 1" risers and the fast idle rerouted, just wondering if I can get by without putting on longer cables. I have the front lowered an inch, too.


Thanks in advance, guys!
 
I would say no. I have 3/4 inch risers on mine with helibars and i am pushing it because of the stock cable length.
 
The only thing that could hold you up would be the clutch and brake lines. With the front lowered you should be OK on the brake line but I'm not sure about the clutch line. When I ordered my braided lines I had them made a little longer than stock so I could run the 1-1/4" riser with heli bars, the throttle cables were long enough and with the fast idle cable rerouted it was fine also.
DSC04503.jpg
 
Back
Top