Good afternoon, I've decided to try and take some time and stripping and polishing my swingarm. I have removed everything from the wheel chain, dog bones the nuts and bolts from the bottom of the rear shock, the "special 4 slot nut from the pivot bar and the other one on the opposite side of the pivot bar. The swingarm is loose and ready to remove except from the pivot bar area. I tried pounding it out and attempted to twist it out. Can anyone please advise me on how this may come off. Thanks in advance for help.
06 Busa; Swingarm Pivot Bar issues
- Thread starter 'who'
- Start date
The "pivot bar" is threaded make a tool or try a spark plug socket reversed to thread the shaft out from the 4_slotted lock nut side.
Posted via Mobile Device
Posted via Mobile Device
R
rdavidharris
I tried to "make" my own, but all I did was make a hot mess.
I found both the 32mm 4 pin spanner to remove the locknut and the 24mm allen hex for the pivot shaft. No more destroying a $20 lock nut with a hammer and punch. LOL
Not exactly "cheap", but a heck of alot easier...
eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices
eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices
Hope this works
I found both the 32mm 4 pin spanner to remove the locknut and the 24mm allen hex for the pivot shaft. No more destroying a $20 lock nut with a hammer and punch. LOL
Not exactly "cheap", but a heck of alot easier...
eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices
eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices
Hope this works
Similar threads
