Anyone use these on the Busa

[monster]

(TurboSN95 @ Jan. 22 2007,11:28)

(USN05LE @ Jan. 22 2007,08:19)

(TurboSN95 @ Jan. 22 2007,10:17) Is this basically the tool that you should be using?  I have stock headers btw.

<a href="http://cgi.ebay.com/ebaymotors/Drag-Specialties-oil-filter-tool-Suzuki-fram-NEW_W0QQcmdZViewItemQQcategoryZ35597QQihZ017Q



QitemZ270055001225QQrdZ1QQsspagenameZWD1V" target="_blank">http://cgi.ebay.com/ebaymot....meZWD1V</a>

Link doesn't work.

Don

Fixed the link...

I have a similar one and my ratchet hits the header (stock also). This should work like a gem

 

[Red05]

The HMF header pipes make it almost impossible to hand tighten the new filter. I use the same wrench on mine, works great. I tried to alter the socket type tool to slide on from the side with not much luck.

 

[VaBusa]

Men and all of their fancy toys!

This works just fine...

 

[Big Bo]

I use the pliers too.

 

[300Busa]

pliers here

 

[monster]

(VaBusa @ Jan. 22 2007,12:46)

Men and all of their fancy toys!

This works just fine...

 

[Powers739]

I perfer to use the K&N Oil filter. I think it's KN-138 part no. It has the 17mm nut which is crossed drilled for those who want to safety wire it.

 

[mrninja9]

yep i use a screwdriver punch through the filter havent had any problems yet

 

[bigoltool]

I have a set of those pliers but they dont work great on the smaller Bike sized oil filter for me anyway. I just break it loose with the Suzuki wrench and then use my fingers to spin it off. Much as I hate to say it they should take a tip from Yamaha and put the filter out on the side where you can get to it.