Check the speed bleeders people say to use a little grease around the threads of the speed bleeders. Im having the same issue same set up but mine back and front brakes. here read this https://www.hayabusa.org/forum/general-bike-related-topics/124815-no-clutch-lever-pressure.html
I rode from ohio to the dragon one year and found out at the dragon. I had no rear brakes went to wheeler and had them bleeded and rode the dragon got home and had no rear brake wth. Now the bike sat for the winter now I have to bleed every thing back brakes clutch and front brakes any Ideas. I...
Why do I read on other sites to go bigger battery cables. Should you really do this and what the pro and cons about doing this mod. And is their any one here that sells them on this site. And what is the gauge of wire should be used.
Ok I had the fan run on the bike working ok but when I put my HID high beam on it drains the power from the fan and you can hear the fan idle down some. could the HID high beam be causing the problem of the fan fuse popping.
Mine does the same thing thinking about disconnecting my speedo healer and see try to disconnect my power commander or the HID I keep on popping fuse for the fan it suck when you ride then come to traffic and then find out you pop a fan fuse and just watch it over heat.
I'm just try to keep a positive mind that I might of mess up put in back together because it my baby. Thanks guy will keep you guys updated if it act out again.
I think it was the gasket that was rubbing
on the black collar under the blade I trimmed it go to see if that was it might of put a strain on the fan that cause the fuse to pop.
That black collar had rub mark on it.
Nope it did it again Im hoping its nothing big like wiring harness. Do you think my Hid are doing some thing? Is their any kind of lube to use on the bearing under the blade. Found a little rust under the blade on the corner near one of the screws. can I take the motor apart or is that a bad...
Nope it did it again Im hoping its nothing big like wiring harness. Do you think my Hid are doing some thing? Is their any kind of lube to use on the bearing under the blade. Found a little rust under the blade on the corner near one of the screws.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.