Recent content by ToyBusa

  1. ToyBusa

    Wilbers 641 on a Hayabusa

    Yeah, I figure the inside of the pillion pegs is my only option. It's difficult with the 'Busa because there's no exposed subframe on the inside, and I've got the racking and another set of feet on the outside. Plus I've got a new chain oiler I need to mount somewhere. Cheers, --Rich.
  2. ToyBusa

    Wilbers 641 on a Hayabusa

    That was all loaded up for our trip to the Phillip Island MotoGP '18. Gear - Ali-Lite Deluxe Tourer motorcycle trailer w/extended drawbar & w/esky rack Coleman 8-person Instant Up tent Evakool Icekool 35lt esky Classic Industries towbar SW-Motech topbox & pannier racks Givi E55 Maxia topbox...
  3. ToyBusa

    Wilbers 641 on a Hayabusa

    Has anyone fitted a Wilbers 641 with both the remote expansion reservoir and the optional remote pre-load adjuster to their Hayabusa? If so, how and where did you mount your remotes? Obviously, this is not the standard "piggyback" cannister model offered for the 'Busa, but as you can see it...
  4. ToyBusa

    Fuel filter mod

    I completed this mod on my 08 gen 2 today out of necessity. It's drag racing season again here and after 3 rounds I couldn't figure out why I was still 0.8s off my fastest time. The bike was getting to redline but just not quickly enough. Someone mentioned a Busa owner they knew who previously...
  5. ToyBusa

    Help identifying mystery rubber cushion.

    Found it! Lower right sprocket cover bolt goes through it. Hayne's '99-'13 Edition Chapter 6 Section 18 Photo 18.6d
  6. ToyBusa

    Help identifying mystery rubber cushion.

    2008 Gen II Hayabusa. While removing the engine for a transmission change, we wriggled the engine a little to get the chain off the sprocket. A rubber cushion dropped out from somewhere just rear of the shift shaft or maybe behind the side stand attachment point (stand had already been removed)...
Top