Recent content by Toyabusa

Recently I installed a lock up clutch on my 1300 hayabusa, the stock hydraulic clutch cylinder is not strong enough. I have to change gears at 6500 rpms and if i go pass that my clutch wont release. Do they sell an aftermarket clutch cylinder that i can mount in the same place as the stock cylinder?

We had a weak fuel pump we fixed it and secured it. It was low on pressure. We also figured out that we weren’t letting the engine warm up enough and that made our spark plugs go out to.

So im going to have to be very descriptive here. So I’ve had issues with my gas pump where there is a black rubber seal that looks like a spring. It keeps coming out or getting out of place so we fixed it and thought it was set but now I have the same issue where my engine won’t start cause of...

How does the reserve bottle/ catch can work on a 1300 hayabusa. I’m having an issue with my radiator shooting water into the reserve but it won’t go back in resulting in over heating problems.

Well I finally figured out the issue. I had put in a set of used but clean spark plugs in when I changed them and I bought a new pair just out of desperation and she fired away and sounds better and runs better. Thank you for the input and excuse my silly mistake. Thanks.

I was saying my stator wasn't burned up that's what I meant by cooked everything is hooked up fine

Could you explain a little more please

Everything is installed properly. Battery is up to 13v now and enough to start up but won’t start up yet

I start off with 12.5v and when cranking I have 11.6v but it has started while having that before. But the spark might be it because it was a small spark and could barely tell it was there.

My Gen 1 1300 hayabusa has spark and there is fuel going to it but it wont start. It cranks but it wont work up to actually run. What could be the underlying problem? I hooked up the dealer switch but no codes have shown. I recently changed the tps and positionEd it where it needed to be. It was...