Recent content by tinmann840

It just spins

The starter on my 05 will turn the motor over then spin. I've pulled casing on the starter clutch and it spins one way freely but not the other. I've charged the battery on a trickle charger for days and it shows a good charge. I have checked the 30 amp fuse on the solenoid and even changed the...

I think this Busa has seen it's last days as a streetbike. I'm sending it to Utah and having a tubo motor built with a stage 2 with water. Scott and I came to a figure of around $7700.00 a couple of months ago but I'm willing to go a few stacks more. I have the BKing to street or maybe buy a...

That part in the picture is n umber 22. The clutch push piece.

Wow, good thing I have a BKing. 30 views and not a response is the same as seeing another biker broke down on the side of the road and hammering right on by.

I bought new clutch plates and I'm sure I installed them in the proper order, beveled metal ring washer first bevel out then then flat ring washer, first and last fibers are the thick one and forth and fifth metal plates are the thicker ones. My issue is the pressure plate thrust pin does not...

It's from a 2005. It's smoothed out considerably, fires right up. I ordered he hardware I was missing for mounting the exhaust and I also needed the sleeve that fits inside the gas tank bracket and one of the rear seat grab bar bolts.

I just swapped the engine out in my 2000. The old motor had lost compression and would not start so I opted to buy another motor, gas tank (painted to match) and internal fuel pump. The engine came as a kit with everything including radiator, oil cooler, throttle bodies, ecu, harness and stock...

I bought another engine last weekend and the throttle bodies have 2 vacuum port nipples missing. Is there a way to plug these or does it matter?

I rebuilt the stock fuel pump, new gaskets, o-rings, basket filter and even a new fuel cock but still won't start. It turns over hard, harder when I turn the throttle but only when I spray starter fluid in the air box will it start briefly. You can hear the fuel pump prime when I turn the key...

I got a set from Joe for my B King and they give me the room I needed to tuck my knees Under the air scoops on the sides of the tank. I have tried them on my Busa yet.

Thanks guys

What's the best tool to use for removing and install male and female pins in plastic connector?

I think there is a special tool to remove the ignition cylinder. I totaled an 04 front end and had to replace almost everything. I think I use a T 20 security Torx .

The Causeway brings back memories. We'd go out there or Gandy Bridge and race all night or until the police showed up.