Recent content by The_Punisher

  1. T

    PC3 map download

    I have an 02 Hayabusa with a full Yoshi, single exhaust/ K&N filter, I was going to download a map for this setup on power commander's site but they do not have a map for this setup. Is there a setup I can download thatll be close? Thanks
  2. T

    Extended swingarm issue.....

    I found some answers to the brake caliper arm... So I just need to find some spacers that are a bit smaller, anywhere I can find them?
  3. T

    Extended swingarm issue.....

    I purchased an used 4" extended swingarm, I installed it today and went to put the wheel on and realized the oem swingarm spacers are about 1/4"-1/2" to wide to fit the slots. I was not provided with suitable spacers either...also the brake caliper arm does not have the length (obviously) is...
  4. T

    High Beam not working

    Ended up being the ballast, something mustve shorted out on the board. Swapped it out and everything is good! Thanks guys
  5. T

    High Beam not working

    Yea im thinking the wiring for the HID ballast , ill take a look at it
  6. T

    High Beam not working

    It is the fuse, replaced it and it blows instantly once I turn the high beam on...
  7. T

    High Beam not working

    Ill do that, just gotta figure out where it is >_<
  8. T

    High Beam not working

    Yes it is, but the High Beam indicator on the dash isn't coming on either.
  9. T

    High Beam not working

    It does nothing, I did it repeatedly on my ride home last night, and also tried a few times today.
  10. T

    High Beam not working

    02 Busa, I was riding home last night and went to switch on my high beam without success. The High Beam indicator lamp doesn't illuminate on the dash nor does the high beam come on. Headlight switch gone bad?
  11. T

    High Idle Issue

    Ill pick up some thread lock and apply it and see if that's changes anything...
  12. T

    High Idle Issue

    I do use the choke when its cold, as you said, it barely idles without it...and with the choke on, it idles where it normally does...but once warmed up and ridden the idle gets high as well as the choke...
  13. T

    High Idle Issue

    There is no change, Also after I adjusted the idle back down, I revved it several times and it stayed at the 1200 I set it to. It was only after I was really getting on it that it went back up
  14. T

    High Idle Issue

    So an update after a short ride... I adjusted the idle down to 1200 rpm yesterday, rode around "normal" a bit today, seemed to be fine. On the way home though I was getting on it pretty good, got in the driveway and its back to its 1800 rpm idle...so it seems to me once I reach the higher RPMs...
  15. T

    High Idle Issue

    Ive owned the bike since 6k...never touched the tb's. I can check them out though, what needs to be done to ensure they are synced?
Back
Top