Recent content by suz951

Ahhhhh Hellllllll Nawwwwww Here We go!!!!! wheres the  

Haya Creekgirl and welcome! <!--EDIT|suz951 Reason for Edit: None given...|1137806754 -->

I run 17/45 works great  1.46 60fts   <!--EDIT|suz951 Reason for Edit: None given...|1136513320 -->

HEY....welcome to the site... and congrats    the bikes a legend...   every thing else is just R&D   enjoy

1911 miltary spec. its thin and all steel, runout of amo!!!!!!    makes a good club  

191 on gps, all stock befor mods, only pc3r with timing change, made my own TRE.

Mang that ruffalow or cow is one thuuugly bike, it needs <!--EDIT|suz951 Reason for Edit: None given...|1135036340 -->

How good are the stock head pipes.

Can the TPS be adjusted for more fuel, or is it for timing?

Ok!!!!!!!my falt.....last yellow

Hello I have found out the easist way to launch is pull the choke, its only a fast idle, I have mind adjusted to about 4000 rpm, shallow entery on the last yellow, leave on the last green wtfoook open slip alittle and hang on, shift at about 10,000, due to reaction, by the time you do shift...

Hey thanks, I checked the noise with a stethascope , noise at rt lower around bottom of engine, more by clutch, but diffently bearing rollover noise....

Hello....I have a 05 Busa, about 1300 miles, when warmed up and at idle, has noise i can hear and feel in hand grips, sounds like bearing rollover noise, kinda goes away when clutch pulled in, with clutch out in netural, give a little gas when rpm comes down noise comes in around 2000 rpm

Shid man I got a 05 buus......1233 miles, lucky if I get 2000, hammer the throd at 4 gran in 1st and hang on.. bang 2nd.....200 heal to toe line on the asphalt baby......... not the fastest....only in the middle of the pack till the last lap baby........use the curb feelers on those pegs......

From 80mph.....to 1.5 miles it bumps the rev limiter about 11100.....