Recent content by supernova777

From what i understand the "variobar" intended for installation direct to the fork (ussualy under the upper triple tree) but in my case this is too low.. Thanx anyway gixerhp!

Questions? ??? Your post is the definition of a complete response! :bowdown: Thanks again man..

Thanks guys for the responses but my main problem is that i don't know the maximum permissible diameter: how wide can be the spacers -not the height of them (this will be variable!) The soupy's are 1" wide,but i calculated that i need at least 1,3" wide (at diameter) spacer- is this possible or...

I am working (mentally) a project for variable handlebar geometry and i need some help.. The basic idea is helibars (variable angles already) with variable risers (like soupy's but with variable height-this is my project) Of course the break and clutch lines (and free the throtlle cable) are...

Tell us all the story first! :laugh: ...

ok, thanks again guys! I'll be change this battery as soon as possible..

Thanks guys ! From what I understand fuel vapor lock happen inside fuel lines, pumps etc so the starter motor runs but the engine don’t start.. In my case the starter motor struggling for a moment but then the engine start instantly In half rotation or so.. It’s looks like...

Hey guys, i notice something weird: My baby (09 - 3000 miles- no mods) have a hasitation at start up immediately (2 or 3 minutes) after shut off! It happens usually when i come from a long ride (80 miles or so) and shut off to open garage door, remove bags, etc.. Then, when i push the starter...

Thanks guys! My fear with red loctite is a possible future "accident" (at stud - bolt - threads ) during disassembling either from threadlock itself or the necessary excess heating or just bad luck! I'll test the blue first...

hmm...finally i must re-open this cover! :banghead: ... Thanks anyway for the information!:beerchug: ... (I wrote this with no luck in one older thread) one important information is still missing: the factory install these studs without thread lock or with a non appropriate thread lock ? (...

Problem resolved with suzuki original (wako-china) oil filter..:cheerleader: Thanks again everybody!:bowdown: (And lesson learned:for superior quality don't buy a EU product - the chinesse are the best!):poke:

ok, old thread but finally one important information is still missing: the factory install these studs without thread lock or with a non appropriate thread lock ? ( 1303) have you guys found any traces of thread lock in disassembling while performing tsb? (i can't decide: red or blue...

Thanks guys! The filter is a Champion k 301 and yes tomorrow i will change it with an original zuki.. (Wako i thing is the manufacturer of originals) ok and now the surpise: a friend of mine former worker (chief mechanic) in suzuki motorcycles service department for years he said over the...

ok, for one more time i need help from anyone more experienced :bowdown: to this: oil and filter change-piece of cake (except the right fairing removal :whistle:) BUT the oil filter it does not seat flat in case!:banghead: the threads are ok and filter is not crooced or something but at top...

Thank you Smac for your input! I know that these babies are hot but in another approach the main reason of rectifier failure is the very high temperatures. My stupidity is that i didn't measure the charging voltage before the change with the cooling fan on.. Dadofthree i did the recall for...