I bled the old school well yesterday and got it to build a little bit of pressure I'm no longer getting any air out of it so it may be the master cylinder
I'm just wondering exactly how long it takes I replaced the rear brake caliper I've been using the vacuum pump and I used Teflon tape around the threads of the bleeder valve. I've been working on this for 2 days for about a total of 6 hours I finally have some pressure but it doesn't start...
I believe that's it I didn't realize it was different only had the bike three weeks and only rode once . I noticed the rear brake has lots more braking power than my previous bike that was all stock . I appreciate all the help
It's not stock I have a aftermarket swingarm and I'm not sure how to get another as far as getting this same one I took measuments it has 4 - 32mm pistons
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.