Recent content by rob702

  1. rob702

    2005 cam chain tensioner

    Chain stops rattling after I get the loud click
  2. rob702

    2005 cam chain tensioner

    Thanks for the reply I think it sticks a few times over the last year when I have gone to start the bike up I get a cam chain rattle which is ok but then a loud click so I thought I would change it to be on the safe side Thanks Rob
  3. rob702

    2005 cam chain tensioner

    Hi I am going to change the cam chain tensioner on my 2005 (fitting standard suzuki one) will I have to remove the cam cover or can I just unbolt the old tensioner and fit the new one any tips or advice would be appreciated Thanks Rob
  4. rob702

    Fuel system not holding pressure

    Thanks for your reply yes I am just concerned with the pressure dropping after the pump primes as most systems hold pressure even when turn off for a short time, maybe the hayabusa doesn’t Thanks Rob
  5. rob702

    Fuel system not holding pressure

    Thanks for your reply the reason I asked the question is when looking on the web for injector pump problems they all say you have a fault if the system is not holding pressure when turned on or off , which makes sense as on my bike once the pump has stopped the pressure drops to zero instantly...
  6. rob702

    Fuel system not holding pressure

    Whilst I am waiting for my pump to be delivered from the states I thought I would try putting a fuel pressure gauge on my old pump, my bike is an 05 when I turn the ignition on the pump came on for a few seconds and the pressure went up to 45 pounds but as soon the pump stopped the pressure...
  7. rob702

    Wiring a gen2 fuel pump to a gen1

    that was quick thanks
  8. rob702

    Wiring a gen2 fuel pump to a gen1

    Anyone know how to do this with the gen1 having 4 wires and gen2 having 3 Thanks Rob
  9. rob702

    Gen 2 fuel pump on Gen1

    Thanks for your quick replies if its just a matter of changing the plug I will get a gen2 pump Thanks Rob
  10. rob702

    Gen 2 fuel pump on Gen1

    Will a gen 2 fuel pump work on a 2005 gen1 as I need a pump and gen 2 pumps seem cheaper And obviously newer Thanks Rob
  11. rob702

    3000 RPM surging

    I stripped the fuel pump today and washed the filter in a bowl of fuel lots grit and little specks of rust came out and the strainer at the bottom of the pump had lots of rust stuck to it. Put the bike back together and went for a ride, bike seemed OK so think I need a pump or a filter. The...
  12. rob702

    3000 RPM surging

    My mileage is 13000 and mods are ti force 4into1 small air box mod and re-mapped but this was done a couple of years ago and the has run great until a month ago could it be the fuel pump ? When I got the bike it had been stood for 3 years and had a lot or surface rust in the tank
  13. rob702

    3000 RPM surging

    Help my 2005 when riding below 3000 rpm feels like the bike is surging and if you open the throttle the engine seems to miss before taking off . I can go back to the bike a hour later and the bike will run and ride perfect When the fault occurs the idle speed drops from 1200 to 1000 rpm and...
  14. rob702

    Gen 2 coil pack

    anyone know if gen 2 coils are the same as gen 1 my bike is a 2005 Thanks Rob
  15. rob702

    Road riding with clutch mod

    Thanks for all your replies you can’t beat asking people who have been there and done it
Back
Top