Recent content by Rivercop UK

If its going to be permanent, then personally I would take the pegs off and spot weld the weights on. You get nothing coming up into the foot area then.

I had my letter from Suzuki earlier this month ... I'ts been down and changed yesterday.

I tried running hotter up the rev range on later runs and I was only hitting the high 180's / low 190's. On one or two runs I hit the rev limiter which is no good. When I did this run I passed the timing mark at just at the edge of 6th gear rev limit. I think I need to add a 55 profile tyre to...

Full exhaust with decat, ECU tuned, BMC race filter, ram air tubes sealed, debaffled end cans, -1 rear sprocket, PC5 with wideband and autotune. I short shift as 9500 is where peak power is.

[/URL] Well there's always next time ... Or a Supercharger.

I'm packing a 4.5mm ball bearing Co2 powered Sig X-Five ... It can make tiny dents in my garage door.

Very nice, but please get shot of the frame warning stickers ! :banana:

Love it .. Really love it. I've always been an Orange kinda guy. I need to learn to spray !

You are supposed to change the oil before storing it, as old oil can cause minor damage if left sitting too long. Oil can take on quite a bit of water if left. A good half an hour blast out should cure all ills. You notice this with a clear clutch cover ... There's always condensation on the...

PC3 & PCV maps are not compatible. Best get a near enough map downloaded or get a quick dyno run for a personal base map. Bear in mind, I downloaded a map that basically matched my setup. I then hooked in an autotune box which then changed the map quite radically. So personally it's worth...

Talking to a guy (Phil) who's a regular speed freak and drag racer. His mate brought a modded Blackbird down last year and after 5 runs only managed a top speed of 181mph. Phil jumped on and got an impressive 195mph 1st time on the bike. He said a lot of the mph gain was the start and body...

Well the bikes all set other than a few 100% throttle 5th and 6th gear autotune runs .... Booked in with Straightliners for April 11th at Elvington .... Getting excited already !

Black Widow stuff is cheap but reasonably good. Not up to the quality of Akro or M4 but you get what you pay for.

Got the Busa out for the first time since November and after all the mod's I've been doing. Sunny day, dry roads but cold. Had to take the Busa for its annual M.O.T. test at a garage about 10 miles away. So set off nice and steady until the bike warmed up ... Then you know what happens ...

I test them all with a program (H2testw (Windows)) that writes to every bit of the card then reads it all back - It tells you the real speed rating and the real hardware capacity along with any bad sectors - Picks up any fake card every time. A lot of fake cards these days are actually genuine...