Recent content by race24x

Here is a shot of the bike

Thunder, If you buy Suzuki SV650 dogbones and replace your factory ones with these, it lifts the back end up about 1 1/2 - 2". I did notice the increased steering angle and I liked it. I am also 6'4" tall so the height was too low for me in stock form. Changing these is a very simple job. The...

I am also interested in lowering my pegs. I put the SV650 dogbones in that raised my bike about 2" in the rear. It made the steering more responsive (it felt a bit sluggish stock compared to my older GSXR) I use all but about an 1/8 of an inch of my rear tire, when I am riding hard with my...

Mine does the same thing, but it is my rotors I think. They are made to float on those round pieces and have I beleive a spring like metal that holds them semi tight. Well after considerable miles mine are a bit loose so everytime I hit a bump it is an awful rattle. Also one side must be more...

Hey guys another new year same iussue. I didnt work on it much at all over the winter. I am looking at a few suggestions I thought I would try. 1 Someone mentioned voltage. I did have an issue with my voltage regulator out back and had to fix some burnt wires. Sometimes I feel like my headlight...

What is redline in 5th gear. I shifted into 6th and let up. Stock gearing on a 2000 Busa. She is fine with going fast but did say trying to tuck at that speed the helmet had wind under it trying to pull it off. I figure about 165 or so just a guess, my speedo hasnt worked in years. I try to keep...

What parts need to be replaced for this upgrade? I am looking on Ebay right now. Starter starter clutch and idler????????? 99 07 2005 05 SUZUKI HAYABUSA GSX1300R OEM STARTER CLUTCH GEARS WITH MISC | eBay I found this on Ebay

Thank you man I posted over there. I hope this helps the surging I am sure being able to program the ECU will help some

This seemed like a great way to upgrade but has anyone done it I can't seem to get any answers

From what I read I thought I could've use the same harness just change some pinouts and by stator do you mean the cup part or the winding part.

I need help identifying exactly what parts I need for the 32 bit upgrade. Has anyone done this and can you help me please? I see from other posts a stator is required but are we talking the cup part that moves or the winding part that is stationary? I need to change a couple of wires in the ECM...

No I am not even sure ow to check it. I am not even sure if when everyone is talking about for stator they mean the cup part or the winding part or the other side of the motor

When you say rotor, do you mean the outside cup part or the inside part with all of the copper windings????

I still need some help with this thing. Its stilllll driving me crazy. I am now trying to upload a new map in my PCII but I get upload file incompatable when I try to connect. I really would like to do the 03 upgrade but I cant find anyone that has done it to give me a list of specific parts I...

Good luck man no one seems to have a real answer or fix