Recent content by pseudo

You should be fine as long as it's not prolonged or heavy riding, in some cases you can burn valves, but it is rare. Sounds bad ass though.

Wish list status: OEM wind screen ### THANKS PCOSHO!!! ### Passenger peg set ### THANKS DVLDOG!!! ### Still need: An OEM clutch basket with friction plates and steels. (badly) A rear OEM brake rotor and perhaps pads. (badly) An...

I know a lot of people take new and or perfectly good parts of their bikes for aftermarket gear. I'm looking to save some $$$ and am hurting badly because my bike is my only mode of transportation (UGLY DIVORCE). Seriously down on my luck and funds. So here goes... I'm looking for...

I hope to take a better one tonight or tomorrow. But they are awesome mirrors huh?

I took this video today, about2 hours ago.... I duct taped the camera to my helmet but unfortunatly, angled it too far down. I'm a dumb ass. But you get to see some really cool rear view mirror shots and canyon cutting at a buck 20. Here it is: I can't wait to get back out and get a better...

Along with replacing my fork seals, my clutch just gave out ... *sigh* It's slipping in 1st gear only ... Any suggestions on where to pick up new springs and plates for as cheap as possible? I'm really tight on money and need help please! Thanks.

Enjoy!!! "Almost" top speed run on Pennelope.[/url]

Well, I got my wheelies down pact, but here's the deal, I blew my right fork seal during the learning process and now need a rebuild. How much should I expect? And what's the best way to get them off? By the way, it's leaking BAD. is this a good time to get my steering damper oil replaced as...

I'd like to see pics. Until then, it doesn't exist. I don't care what any of you say!

Dude! I know Jason! He just pieced out his Busa! I'm thinking of buying some of his stuff if I can find the $$$. Where are you at?

I've already started to get better on my wheelies. I'm going to practice clutching tonight. Roll ons are dead simple, the key was timing the second dump to jump off the springs. My seals are already leaking. I asked my dealer how much, and they said $200 for parts, and $200 in labor? WTF, your...

So, I've finally started getting the "balls" to start doing wheelies on the Busa. I've figured out how to do a power wheelie, but the acceleration on those make me a bit nervous. I had a few unexpected 9-11 o' clockers. I try to clutch wheelie (which I hear are easier to control) but just cant...

Nice! I always wondered what the Bus looked like on the track.