Does anyone know how to remove the front mudguard off an Gen 2 Busa? I have a 2019 I'm trying to take off. And how do you disconnect to plug that's connected to it?
I installed the Brock’s Alien Head 2 on my 2019 Busa Friday night. I'm getting an FI error. Is that because it's new & needs to run, because the stock O2 sensor isn't on it because it doesn't fit? And is it normal for your header to smoke a little? It's smoking some on the inside of the header...
What pins are you talking about? I got the same error on my 19 Busa. dont have the O2 sensor on, stock O2 wont reach. I'm going to buy the Code C44 Eliminator Plug and getting it flashed in a couple of weeks.
@geecare Does it matter which frame slider goes on what side?? I can get one tight on one side & the other the screw bite with the frame slider, but the screw will bite without the frame slider...
Yeah it is. Had to get the allen head to pop off so I could pull the bar end off. I tried channel locks, but as you can see by the marks that those didn't work. I'll try my vicegrips. Anything I need to do to make it turn easy out of the hole? @Popie
Would I need to heat up the screw to get it to come out while using the vicegrips or anything on the screw itself for grip? Earlier I tried channel locks before posting but that didnt work. First time taking the screws out and the were in there real tight. @Dustin02
I NEED HELP...
So I've been fighting this bar end trying to get it loose. Someone here shared a post with me that helped me get it off. I got the right bar end off that I didn't try yet before learning how to properly do it. I go to the left bar end that i started with, and the allen screw was...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.