I found what I needed. For anyone needing an online manual .pdf
https://www.slideshare.net/hayabusabr/hayabusa-servicemanual-19992000
Rear suspension settings: pg 6-53
Front suspension settings: pg 6-29
I have an all stock suspension on my 2000 Busa. I need to either get the manual or the different settings that are shown in the manual to get a baseline.
Can anyone help me with either?
I messaged them and they said: "I dont make those. Get in touch with steve or chaz landers thru facebook. Tell them i sent you over they will take care of you. Michael Tona-SAE Outlaw Performance"
I'm still wanting to find a lighter, better thoughout setup than the Chop A Leg hack job.
Hi, I tried to call you today from my cell but Verizon message I received said your phone has restrictions that keep your phone from receiving calls from my number. Can you send me a PM or ring me? 801-814-6073
I've got a Gen-1 that has a small ding in the rear left of the tank. I'm pissed because someone (one of my kids or roommate) dinged it while the bike was in the garage under a cover. I want to find either a carbon fiber tank cover or a color matched tank bra that will cover it.
If you have a...
Michael I tried to text you last night but didn't get a reply. Did you get it? Or should I make an actual phone call? I'm curious as to what your new axle looks like. Does it fit R1 wheels? Can you post details.
Yes it doesn't appear to be self-centering, and Steve told me the same. It also appears to be slightly too long, which I hope I can rectify when I have it redone.
LOFL.....it's a piece of crap, cheapo thing to do. I also don't know why he made it out of stainless, the thing weighs 5 lbs-so much for my weight savings from putting on the R1 wheels.
Yes I did, why? It's super heavy stainless steal and the end bolt is a POS cheap thing from Home Depot. LOL. If I end up keeping this bike and wheel setup I'm going to have the axle remachined out of 7061 including a nice bolt.
1st Gen-2000.
When I removed the leftside fairing panel this metal piece w/rubber end protector fell off. I can't figure out where it goes or for what purpose. It doesn't have any mounting holes to speak of.
I was hoping someone would have the same axle as mine and be able to give me some insight.
I bought this as a non running bike with 5700 miles. I've yet to ride it which is why the forks are so nice.
Tell me about it. I can't believe the guy went through all the work to do this stainless steel axle and then capped it off with a .25 bolt and washer from Home Depot. lol. Believe me I've already got plans to have a machinist make me a nice low profile one out of aluminum.
And yes those are...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.