Recent content by metalli445

Thanks for all the suggestions! 1busa I think I'm going to go the same route that you did on solving this overheating issue. I don't want to have to worry about it this summer. I started looking for a Gen2 radiator with fans and noticed some of the radiators I was finding are black. Are these...

Can I replace my stock fan with something more powerful instead of adding a second fan. I'd like to add that as of right now I have a stock exhasut system but I would like to go with a full aftermarket exhaust system and I'd like for my cooling mods to not interfere with the exhaust. I will not...

Hey Guys, Today in Maryland it reached about 80 degrees and of course I got stuck in a big backup. I was surprised to see my temp start to climb as I was sitting there under these conditions. Luckily traffic started to flow before I hit the red and the temp came down to normal. I've had this...

To mount the iPhone 6+ I ordered RAM-B-149Z-UN10U and RAM-B-342U. I will install it later tonight as the missing double socket arm was left out of the original order. They sent me the piece at no cost. http://www.rammount.com/part/RAM-B-149Z-UN10U http://www.rammount.com/part/RAM-B-342U

After some more reading it seems Vesrah JL is also a pad that needs to be considered.

Towards the end of last summer my brakes started squealing and I know its been a long time since the pads have been replaced. I can't remember what brand I last used but I also think my rotors might be a little warped. I'm finally getting time to work on the bike as the weather begins to break...

perfect! Thank you. I contacted Ram mount and they are going to send me the double socket arm they forgot to send me. I can't wait to actually use it. lol

Thanks! Did you find your phone sits up to high and hides your gauges? Would you buy the same size again or go with something different?

I just received my RAM mount but it appears I still need to order a piece. I received the x grip that has a ball on the back and the stem mount that has a ball on it but not the piece that connects the two together. I'm not sure of the proper term but what size or kind of stem should I buy to...

Where did you mount the USB charger or is it laying in the battery compartment? Pashnit has a lot of different options for the USB Charger. Do you remember which one you purchased?

Thank you for all the reply's. I think I found the right model. I'm going to get the RAM RAIL U-BOLT MOUNT X-GRIP 5" PHABLETS (RAM-B-149Z-UN10U) which comes with the u-bolt base. It appears I also need to buy the UNPKD RAM CYCLE STEM BASE W/ 1" DIA BALL (RAM-B-342U) since the u-bolt base that...

My phone in the case measures 3.5" wide.

Hey Everyone, I have an iPhone 6s Plus with an otterbox case. I'd like to mount my phone on my triple tree to use as my GPS. Does anyone know of a company or product that will allow me to quickly clip my phone into a holder while still in the case? Is there a way to run power so the phone...

Hey everyone. A few years ago I purchased a 230CCA battery. I believe the model was a 14S which required the bottom of the seat to be cut in order to fit the battery. Well it's time for me to purchase another battery and I've heard the Ballistic batteries are really good. I was wondering what...

Damn... I didn't even think about a fuse issue. I'll check that tomorrow after work. I hope that's all it is but then I wonder what would cause the fuse to blow.