Recent content by mcantar

Headlight is being redone. Wasn't happy with it at all. It's wearing an MT-03 in the meantime.

It's done for this year. Will pick it up again in November and take it to it's next phase of life.

That'll work. Thanks!

Does anybody sell a bolt kit for the Busa? The time savings would be well worth the cost, but I haven't been able to find anything.

Depending on your application, a pound or two of rotating mass can make a big difference.

I have one for a Gen 2 somewhere... let me know if you can use it.

Got the speedo and tach working. Now I need to figure out the water temp, oil temp, and FI light.

Got it figured out. I missed the VCC wire, overlooked it thinking it was something else until I went back to check the wiring diagram for a different issue. I jumped the speedo ground into the main gauge ground, the speedo power into the VCC, and the speedo signal input to the pink wire going to...

I'm not sure if this qualifies as a Busa problem, but it's a problem and it's on my Busa (a 2008). I'm trying to install a Koso RX1N gauge, and I'm having an issue with the speedometer. The Koso came with a short harness, and on it there are 3 wires for the speed sensor. On the Busa, there is...

Well I've got it mostly together. Have all the idiot lights working, with the exception of the FI/check engine light as I'm not quite sure where to pull that from yet... if it's even possible. I think I have the tach working, will test ride tomorrow to confirm. Main thing giving me an issue is...

Specifically an RX1N? I'd imagine the RX2N wiring would be very similar as well, if not the same. I'd like to attack this tomorrow but I don't know if I can pull signal from the OEM gauge harness wires or if the Koso reads things differently. This is on a Gen 2, by the way.

Thanks Ray! I have a few pics of your Superbyke saved to my ideas folder from when my build was in the planning stage, you've got a badass bike on your hands. Little update for you guys. The bike is back from the tuners, here's the dyno sheet: If any of you are in the Denver area, check out...

It runs! Posted the video in the build thread.

Well, my tuner was messing around with it last night after I left and found the issue. Something about the harness ground, I'm not 100% sure but it functions now. Well, the OEM gauges (that are hanging off the side of the bike) turn on and the pump primes, anyway. Have to set the cam chain...

I think that's our next step Kevin. I'm about to head over to his shop (brought the bike there yesterday), hopefully I'll have a positive update for you guys later.