Recent content by Kevs2579

  1. K

    2011 Clutch fault in ECU?

    Just an update, after a whole lot of testing & checking circuits etc, I understand now why the "clutch in" signal is seen by the ECU: To start the engine the clutch lever/switch when pulled in, earths the B/Y wire, now the B/Y wire goes to the ECU, "pin 60" (Clutch lever switch) so you would...
  2. K

    2011 Clutch fault in ECU?

    But with the ECU wire disconnected/cut/not earthed, the data is telling me clutch in, which means Neutral Map. my understanding is that with the ECU wire not earthed it should be clutch out,
  3. K

    2011 Clutch fault in ECU?

    Ok will try earthing out the sensor on Startup, The give away is it starts in any gear in including neutral
  4. K

    2011 Clutch fault in ECU?

    Type error, its a 2011 Gen 2, Had a thought last night, because of the TOS removal feature in the editor, I removed the TOS sensor & wiring, I'm wondering if it needs the TOS working (ie looking for a signal, even though it switched off in the editor) to make the ECU see clutch out signal...
  5. K

    2011 Clutch fault in ECU?

    I am building a car with a 2001 gen 2 Hayabusa engine, Ive stripped the wiring loom of all non essentials, I loaded the US Bin file I have since read & saved the Bin File with WRT changed some advanced settings (disableTOS OEM Oxy sensor, Pair) & flashed it back to the ECU with WRT, all good! I...
Back
Top