Recent content by Jeremy Godo

Thats Awesome. Thanks for sharing!!! That one bike did well with a 9.47 for stock.. good numbers on yours man.. what type of exhaust are you running?

So I am opening a old thread, but i have the r1 rims on and i am spacing out thrvrear caliper. Did anyone get a longer caliper bolt bc of the spacing from the washers? Or am i over thinking it. Pic below shows my space needed to space out.

Awesome!!

Changs to a cable clutch instead of fluid.

So if i do this It could help Me at the race track... Plus i drop weight

My bike is a gen 1. Not sure a gen 2 tail eill bolt up.

Ok i have my new arm on and the 6 over tail is way too short. Can i get a gen 2 8 over tail to fit. Should i go with 12 over or 8 over. My arm is 9 to 11 over.

Thanks dennis. Cani use that stuff on a oring chain?

Awesome, where do you guys get the dupont teflon spray?

Can you use kerosene on oring chains?

Whats the best way to keep it clean and what process does everyone use? After installing a nee chain when do you need to check it. 500 miles? What products do people use. I see we lose a good amount if power from the crankshaft to the rear sprocket.

So i can install the chain and cut them out later on like they did on the busa. Thats cool.

Next chain is a drz2.

Next chain is a drz2. I had a chain a while back break on me hence my newbie questions. Just dont want to bust up my cases.

That makes a poop ton of sense guys. I ended up with the RK maz chain. https://shoprobbushmotorsports.com/shop/catalog/product_info.php/chain-530-max-ring-p-45?osCsid=717ef1da680fb0b4570709cddb6ccc71 Was referred to this cat