Ok... I'm really stumped on this one. The clutch worked fine before I changed the clutch slave. Now it doesn't want to disengage. Keep in mind this is mounted in a car. Not sure if I'm thinking correctly, my thought is that I push the push rod all the way in the shaft (bike sprocket) should turn...
Hey All,
I recently purchased an aftermarket clutch save that can be mounted at different distances from the engine. Now that I have it mounted I have to cut the push rod. First attempt and I think I have the push rod too short ( I have a spare) I see it move between a 1/8th and 1/4 inch but...
All fixed now... must have been a loose connection. I removed it and tested ohm range with lighter and then jumpered it out and gauge maxed proving wiring was ok. reinstalled and all good now.
Thanks Mabusa..... I still have no temp reading when engine is hot... not sure how to trouble shoot ? worse case I may add a aftermarket temp/pressure gauge if possible. This is in a car so I have room on my dash.
Hey All,
This engine is new to me and my temperature gauge isn't working. I ohmed what I thought was the sensor and it was ok. When I power on the needle does move a bit. The odd thing is that when I hit the kill switch and leave it on I get CHEC on dash and my temp gauge maxes out...Is that...
Hey All;
Please don't shot or roast me, I recently purchased a kit car with an Hayabusa engine in it. I know it's wrong to butcher a fine operating bike to create a car. It was a good deal for me so I made it.
One issue I have is that the temperature gauge doesn't work ( Never moves). I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.