Which sidewinder exhaust would be best for a stock motor Gen 2 Hayabusa on a 60hp dry shot? For drag racing?
Also, should I run baffle or no baffle?
DME Mark 1
Chip Ellis Tater Gun
Brock's Performance Tiwinder
Thanks
Mark.
I am about to install a DME Quick Access Clutch Cover on my Gen 2 Hayabusa.
I am a bit afraid to cut my right side plastic to fit the Cover.
Can anyone give any tips and tricks on how to successfully cut the plastic?
Thanks
Mark.
I got my HRP top clamp from Billy Ammons on Facebook. It didn't have integrated clipon mounts though so I ended up using UNIT5 Clip-ons with the HRP top clamp. If you are looking for a top clamp with integrated clip-on mount look up alifperformance on Instagram
What fuel would you recommend for a stock Gen 2 with a 50 shot dry nitrous kit? For drag racing.
I contacted VP Racing Fuels some time ago and they recommend U4.4 or VPR.
Any one has experience using these?
Is there anything better?
I think I have narrowed it down to:
Edlebrock 71900
Schnitz Micro Storm
NLR AMS-1000
Nos mini (many seem to have issues)
I basically want a simple easy to use GOOD QUALITY controller that can be adjusted on the fly without the need for a laptop or hand held device.
I think I will benefit...
Thanks for the info.
What frequency were you pulsing your nx solenoid at? Do you think adjusting the frequency would help with adjusting down a small jet size?
I am trying to decide which is better?
Nitrous Express Maximizer 5 - $446
Daytona Sensors NC-2 - $300
Edelbrock 71900 Progressive Nitrous Controller - $685
The Maximizer 5 and NC-2 requires a laptop to make changes to the settings. I really like that the 71900 allows you to make changes at...
Hey Dnyce,
Its crossing the finish line at the end of 5th not shifting into 6th .
I tried dropping 2 tooth in the rear sprocket but it killed my 60ft bad also ran consistently 9.0 no 8s.
When I extend the ramp time to 3 seconds it goes 8.9 /9.0.
I am also thinking I may need to slip the...
I have a stock motor Gen 2 Hayabusa currently spraying a 50 shot dry. The bike is tuned by me using Woolich Racing. Bike ran a few 8.80s and one 8.7 so far. I am currently using a basic Nitrous Express Progressive controller hooked up to a wot switch it starts at 20% and ends at 100% (no way to...
I am trying to do some weight reduction on my street/strip bike. I need help choosing between the HRP Fabrication and the Unit 5 Top Triple Tree Clamp.
The HRP has integrated handle bar mounts but the Unit 5 needs clipons.
Does anyone have any experience with these?
Are there any known...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.