RE: The Moto CNC riser bar ordered in November: "We have received your parcel from Moto CNC Ltd and it is now being processed to leave the UK."
I have performed no work on the bike recently. I hope to continue soon...
The bike is an old school version! You gotta get it!
Not only do you want the side stand mod but also a gyroscope to keep the bike up when you are not around. Just sayin'...
The price is awesome particularly in this new climate of escalated vehicle prices. I would be curious about the story...
A good strategic use: PIrates. Launch vehicles onto the Pirates along West Africa. You do not think that a Kia between the eyes will make them think twice?
Aside from cleanliness I can believe that lowering the temperature of chain will extend the life of the drivetrain. @Berlin Germany you have iterated the large amount of oil that your chain oiler uses. I could never spread that much excess oi into the environment. I also cannot argue greatly...
https://www.hayabusa.org/forum/threads/gen-2-genmar-3-4-inch-riser.205503/post-3474239
This had been on my radar and I thank you greatly as I knew from the forum that this would be the max height to prevent having to do other changes .
Soon after this post I ordered the same bar. @911f you got...
Usually upon a loss of income like that the people causing it can be held liable. Given this may be legally protected, that makes it murky territory. However, I would hire an attorney and sue the tenant board and sue all of the individuals within it, for lost income. Even a settlement from any...
As specified in the fork install section in the manual or here, 5mm.
https://www.hayabusa.org/forum/threads/front-fork-height.199246/
Given that the dampener is hydraulic and the fluid goes bad from seal and water contamination, yes. Someone may chime in, but there is likely details on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.