I traced the O/W wire back to the Vacuum control solenoid and I have 12v there.
I also tapped into the Grey wire at the ignition coils and i have 12v there also.
Fuel pump is priming, I can hear it and I can see the fuel pressure on the gauge.
The Y/G wire. No power to it until the key is on...
Ok, tomorrow I'll have several hours to work on the motor.
I did have a chance to take the battery to the shop and it is fine. I really wished it was just the battery.
Ok, I may have some time to deal with this today.
I'll take the battery out and bring it to the local battery shop and have them load test it for me. Hope that's all it is. ......
ONCE AGAIN, THANKS TO ALL THAT HAVE BEEN HELPING ME WITH THIS ISSUE. I am on many forums and you guys at the...
I'll check them again, and do a video to make sure I'm hooking it up right, but like I said in the above post, it seems the volts go down to 9.5 during cranking.
If I did hook it up right to read cranking volts, and it is 9.5, what would the issue be?
Once Again, sorry for not being on here constantly. Work always has me busier than I want to be.
No codes at all. I assume it's because I can't get it running. But I could be wrong, and according to my wife, I'm always wrong. LOL
I pulled a plug off a coil and hooked up my multimeter. When...
Is there a vid on how to check the volt at the coils?
The fuel pump primes fine. I hear it come on when i turn the bike on, I can see it build pressure in my FP gauge. As I said, I pulled the fuel rail with the injectors connected and hit the start button to see if the injectors where working...
Sorry, been away for a while now. Bought a track car so this was on the side burner for a bit. Just finished it up, suspension, brakes, etc. . Now it won't start.
JOY
Hey guys, I have a 2006 hyabusa motor in my kit car.
I'm not sure why it will not start. It worked fine one day, and the next it just cranks and cranks.
It's not the kick stand switch. I have that wired into a toggle switch on the car for extra security.
It's not the tip over switch. I...
I didn't run it out hard. Having some over fueling issues. It's fouling up the plugs, but I'm running stock fuel pressure. I picked up a EGT gauge I need to get installed before I push it hard.
Sorry for not updating this...
I'm a DJ by trade and the fall is very busy. Plus I was adding onto the garage for a place to store/work on the car this winter. (live in PA)
Here's a poop video of the first road test in Sept.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.