Recent content by FlyingSouth

Tested fuel pressure and was only 10psi. Thinking its the regulator as the pump seems to be working and getting enough fuel to injectors to squirt fuel but not atomize it

did a fuel pressure test and all I could get was about 10 psi. going to swap over a regulator and if still bad a fuel pump and see how it goes.

by fast idle are you referring to the choke? the choke doesn't seem to do anything I tried adjusting the idle as well a tad so its still in range without putting the TPS in wrong position

bike was ridden to Phillip island in Victoria Aus from South Australia (fair ride and wet conditions) as the bike left it started playing up some 3-4miles into trip home. it wouldn't go over 7000ish rpm. then gradually got worse and couldn't do any more than 30-40kms. bike got taken to a few...

tried a running 99 model Busa's ECU and did exactly the same. Cam Position sensor and Tip Over sensors also tested fine. going to try and do a fuel pressure test and see how that goes. I can physically see fuel squirting but not sure on pressure.

How did you go with the Crank Sensor? Seems like a similar problem to what I may be experiencing. Made sure furl is good and getting spark and just adjusted the TPS to correct position but still no go.

Battery is new and made sure is fully charged also

Fuel filter has been replaced whole fuel system was been gone through. Cleaned out tank added an inline filter between that and the fuel pump. Brand new fuel filter inside. Pump is working and injectors serviced and flow tested. The are squirting aswell when i crank so i know its getting fuel...

Hey everyone, 2000 busa will crank and almost fire up but isnt wanting to properly start. When it does its only for a second. Have cleaned enture fuel system and can see all 4 injectors squirting fuel in when cranking checked all coils and have spark when cranking. Using CR9E plugs gapped to...

Just tried giving it another go and no luck. I put the wire in to bridge dealer mode then key to on postion. Flicked the start switch to on to display codes. Still no codes just C00 with line up top. Tried adjusting TPS slowly but line did not move at all. I turned all off and put an old tps in...

I will give it another shot. I tried movingvdown and nothing happened then back up etc. But the line never moved.

Hey everybody. Got a 2000 model with Yoshi RS-3 but apart from that everything else is stock. The thing has been sitting for years and just went right through the fuel system getting that right. Now i got spark and fuel but it still wont run. I went to dealer mode and no codes were logged but...