Recent content by FireMedic

Yes, I have a gen 1 but i'm sure I could make it work.

Sounds good about the donating.

Appreciate that. my zip code is 70663? Just direct message me and we can figure out how to set things up.

I see your an Admin of this website and curious as to how to donate. This site has helped me out tremendously over the years.

I'd think I'd be the same part or similar. I'm just needing something to clip the right side dash panel to. How much are you wanting for a nose fairing ?

$$$ If anyone has this piece I'm looking for laying around I'll gladly buy it $$$

That's what I was afraid of and no I do not have it. Just had the bike painted and i'm guessing it broke off sometime during the paint process. Thanks for the reply, guess i'll start looking for a used nose fairing to rob and epoxy. Thanks again!

Trying to find the part number or name of the piece that the windscreen sits against. The top right side dash panel push pin goes into this piece that broke of the front cap. I can't seem to find what this part is or if it can be ordered instead of having to replace the whole front cap. Any info...

Thanks for the feedback, it was the rear key lock that had me confused but after reading your response and looking at it I laughed cause it was simple. Appreciate the help.

just had my bike painted and painter had to remove everything from body work. I picked up the tank and fairings along with a box of bolts, clips, etc... Looking for some instructions or knowledge on how to reinstall the rear lock and latch. Pictures or instructions would be great. Any help...

Anyone know if extension blocks off a 2007 hayabusa will work on a 2003 gsxr 600

Default This project has truly been a nightmare and refuse to deal with builder anymore. 2007 Busa with 9600 miles and 2nd gear went out so I brought the bike to get tranny repaired and undercut all the gears. Figured while motor is open I can do some upgrades: Dyno - 203hp motor w/pump gas...

I/m no mechanic and I am smarter enough to know my limits and stop at oil pan and clutch cover. I thought about removing the clutch hub nut and torque limiter but don't want to get in over my head. The builder and the guy who did tune said it is probably in oil pan. Just don't want to mess up...

Gen 1 Had some motor work done by a reputable builder and welding up clutch was part of the deal. Stock clutch, 4 HD clutch springs with OEM Stack. I've been fighting clutch issues since bike got on dyno. The tuner went for the first nitrous pull and after pull shut down the bike telling me I...