Recent content by feket663

  1. feket663

    Comment by 'feket663' in item 'The first 100 miles after cylinder & piston rings swap'

    This is the monument of first and only hungarian astronaut (cosmonaut) Bertalan Farkas. Here is his Birthplace.
  2. feket663

    OEM Piston ring gap

    One of first starts (after more than 3 hours sucks... ECU's connector's GND pin need replace). Now works flawlessly...
  3. feket663

    Anybody use a 100% "no-fling" chain lube?

    I'm using Scottoiler chain lubing system. For the cleaning only a cloth need... The chain is constantly oily.
  4. feket663

    Typical over heating Gen 1, with a solution.

    I have a K6 busa with lot of mods. I had a massive overheating problem, when I ride on montains, and stopped, the cooling fluid flown from tank reservoir. I changed radiator cap to higher pressure type, changed fan switch to Honda Accord type (lower temperature), made hand switched radiator fan...
  5. feket663

    OEM Piston ring gap

    Good news: my mechanic checked the cylinder head, pistons, and everything is ok... The new piston rings is much "harder" than old (and the old ones looks like worn-out compared the new ones). Tomorrow will the first start.
  6. feket663

    OEM Piston ring gap

    We are over this problem ...
  7. feket663

    OEM Piston ring gap

    Certainly we will check the valves too, if will disassemble the motor.
  8. feket663

    OEM Piston ring gap

    The motor is different, but the cylinder interchangeable. Thu gen II turbo and big bore builders prefer to gen 1 cylinder, because it's slightly stronger, but for street, enough the newer... You can se the differences here: Currently, in my bike the worn cylinder is from K8 Busa too.
  9. feket663

    OEM Piston ring gap

    We followed the K9 repair manual's service data:
  10. feket663

    OEM Piston ring gap

    Few new item for my bike. Cylinder and bolts from a brand new B-King, and original Suzuki piston rings and gasket. With my mechanic, we checked the piston ring's gap, and the size corresponds to the standard size, 0,15-0,2 mm
  11. feket663

    Interesting dyno run on a Gen 1

    It smokes a little at the engine brake...
  12. feket663

    OEM Piston ring gap

    I'd like to thanks for all help, what you give for a poor and stupid East European member. I'm sorry I dared to ask here at all.
  13. feket663

    OEM Piston ring gap

    I contacted few expert, and sent a video, but unanimously stated it's not valve seal or guide problem. If the valve seals would't good, when I start the engine, need smoke, but not in the least (IMO).
  14. feket663

    OEM Piston ring gap

    you can check it at 0:30 and 1:10. Plugs: old pistons:
Back
Top