Recent content by fanman223

  1. fanman223

    Engine miss/stuttering.

    Yes 301 HP at about 8-10 psi, perhaps a bit more but presently tuned back to 255 which better suits the way I ride. BUT. The engine is not stock. Wossner Gen I rods, Wossner turbo pistons, Gen I block with correct gaskets and spacer, ARP cylinder studs, Ported head, Stainless valves, High...
  2. fanman223

    Engine miss/stuttering.

    After a recent RCC Stage one turbo install on a Gen II bike it seems to start and run fine up to 7K rpm. Then the engine stutters like it is missing unless at or near full throttle. Then it pulls great. It dynoed at 301 with stock injectors but had the waste gate spring changed to 255 which is...
  3. fanman223

    C21 FI code

    This just helped me. C21, unplugged after putting the motor back in.
  4. fanman223

    24 Volt Starting System

    I just installed the 1324 auto system from Tiger on a Gen II. But one connection I'm not sure where it goes. A small diameter black wire with a right angle eye connector tagged " Starter Solenoid". I'm sure it goes to the primary solenoid but, the top or bottom connection? I need to get this...
  5. fanman223

    Just pick up my first Hayabusa

    Very nice. Brembo cals?
  6. fanman223

    Lets see your "Custom" exhaust!

    That's some funny chit. :laugh:
Back
Top