Recent content by Cireous

Got a 05’ Busa. Bike Boggs down on the highway but not city driving. Plugs, pump have been replaced. Injectors are good. ECU has been replaced. It runs like this with or without the Power Commander. 1 of the coils is different than the other. Also, the air box isn’t sealed like it should be. No...

Yea it was both switches. I’ve replaced both and everything is fine now

Fixed. Thanks guys. Because I have the 2006 harness, my problem was my start switch. That had to be 2006 also. So I switched both handlebar switches to 2006 and everything works fine

Well I may have it narrowed down. I’m going to be checking the clutch lever switch. All of the above you guys mentioned is good to go. Wish me luck.

If it was blown, I wouldn’t get no dash or fuel pump, would?

2000 tank and pump. Pump primes like it’s suppose to

Im ready to blow this dam thing up. I got a 2000 Busa. I changed out the ECU 02’, wire harness 06’, start switch 06’. Everything comes on lights, fuel pump. No FI codes. I hit the start button and nothing. No crank. I’ve checked all my connectors and switches. I’ve checked the starter solenoid...

I got everything working with the harness. I got another question though. I having problems with my right turn signal. Check my other thread I posted.

My 2000 Busa's right turn signal stays illuminated when I turn the ignition on. My left signal works fine. The right one comes and stays on. I have replaced the turn signal switch. I replaced the start switch. I notice when the ignition is on and I unplug the start switch, it goes out. What...

The fuse is good though.

Yea I understand that part, but I don't even get that. I'm just gonna wait till I get my new start switch. I ordered a new one because the old one was faulty. I don't know if that has anything to do with it.

Now I did find that my start switch was faulty, so that's not on the bike right now. Would that have anything to do with the Hot on the wire harness to the fuel pump?

Got it. Only Gong is, I was testing hot vs ground on the harness side for the yellow/red and black/white, when I turn the key on, I get the ground but no hot in the yellow/red. I get hot in the green/black though

So, the green/black wire is for the fuel level sensor. The yellow/red and the black wire is to power the fuel pump. The black/white wires are grounds coming from the ecu. So for my connector on my fuel pump, would I connect the yellow/red wire and the black/wire to those colors on the harness...

So, I have a 2000 Busa. Ive done the 32bit upgrade on it. Instead of repining the old wire harness, I switched everything out, the ECU, Rotor and wire harness off of a 2002 Busa. Of course I switched the injector wire harness as well, as the new wire harness doesn't mate with the old injector...