It's a sidewinder. I know its recommend to use a relocator but I've measured one before and it's the same height as the oil filter, it will just be a different direction. That's why I didnt mess with it. I can move the header enough to get the filter out because its spring loaded.
I noticed my oil filter is pretty close to my exhaust header. Probably 1/16". Its not touching but seems quite close. Should I worry about burning oil in the filter with it being that close or is it fine?
Think I should put some oil or grease on the gaskets to prevent further rusting? I live in houston where the humidity is over 90% most of the time so your right extremely damp where I live
Slightly worried about later on rust falling into the valves and pitting the valve seats since the the reeds arent there to stop anything from falling in
For anyone who has done pair valve block offs is there suppose to be dirt and debris on the Reed valves? Maybe it was carbon build up? My block off plates from ape required me to leave the reeds in but they were gunked up and I didnt want to try and clean it off with fear it might go into the...
Today I changed my oil. I filled it up to the full line, started the bike and let it run for about 20 to 30 seconds, then let it sit for 5ish minutes. There was no oil in the sight glass which I didn't think such a big deal till I had to add over half a quart to get it to the full mark. Does...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.