Recent content by Busaboo

Hi all, I just fitted a smart tre on my gen 1 hayabusa to hope to smooth things out,noticed now f1 light stays on but runs smoothly compared to before. Can anyone help if this is wrong or normal. Thanks in advance.

Hi rubb, Did you see my images put up on my test.I got 0 on primary test,not sure if I'm doing it right?

These are readings of primary and secondary rubb

Uploaded a few pics rubb, but primary is given me 0 read on 200 ohms

Big respect rubb,much appreciated.

Hi everyone, I hope you are now starting to enjoy your machines again finally. I was looking for the primary and secondary resistance reading on the coils for gen 1 hayabusa, as I got replacements and wanted to make sure they are ok. Thanks on advance

Thanks Berlin,great help.

Just an update,as pointed out to me. ALL PARTS WERE FITTED SEPARATELY, ON DIFFERENT OCCASIONS, AND RODE AFTER FITTED, TO IDENTIFY IF THAT PART WAS THE FAULT. THE ONLY PARTS FITTED AT THE SAME TIME WERE THE STARTER AND STATOR.

Many thanks for your reply. I must not have been clear in my update.All parts where fitted one by one on separate times,every time checked once fitted and warmed up,(DID NOT SOLVE THE PROBLEM),Then finally,the last two parts WERE fitted at the same time.After research, I found the stator was...

Your a legend mr brown.

Starter I reckon

Personally, I feel like its pointing to the starter motor, as leading up to fitting it,nothing else I replaced fixed it.

Thanks, never heard of them.Just checked,not sure on tax at post office,but about £49.Can this not be made similar for cheaper?. Also what is the actual material used for this? Just seems at approx £50 uk for some foam, a bloody rip off,as it's not exactly well made lol from pics I've seen.Is it...

For me,it looks like every thing I can confirm was clean,other than replacement of the pump,I think it was the starter motor, if that helps mate.

Not brought sock yet mr brown,pricey in uk with tax for insulation foam, was looking to see if you can make one for cheaper.