Recent content by Busa_Havens

  1. Busa_Havens

    Quick release pins for tank

    I found these ones, though, after install and using them for a couple of weekends, they don't seem to latch anymore. I need to look into it and see if I can rectify it. That said, they are smaller than the ones posted, but I am not sure I could recommend them considering they may be broken...
  2. Busa_Havens

    Monster Fairings?

    I've got a set of Gen 2 fairings from Amazon for cheap if you're interested. Bought them and decided not to use them.
  3. Busa_Havens

    1397 Plus Spray...

    I have heard that Nels at 2 Wheel Dynoworks is a good choice. I do not have personal experience with him tuning my bike, but, I have heard that he is capable.
  4. Busa_Havens

    Ok friends are sending me this . Busa loosing to a Jeep.

    I'll weigh in here as this is Pacific Raceways (track where this was filmed), my "home" track. I've raced here for the last 10 years on and off, winning several championships on several different bikes. That said, the rider, whose name I will not disclose appears in this video to be quite the...
  5. Busa_Havens

    Towing dragbike

    I do tend to agree. It's a lot easier to "get away" from the bike/pit bike when simply pushing. Maybe I'll scrap the idea and just use the quad for pit support and the pit bike for pushing up to the lanes/back to the pit.
  6. Busa_Havens

    Towing dragbike

    Perhaps a rod through the rear axle that could be used to push?
  7. Busa_Havens

    Towing dragbike

    You are correct that most people use some sort of push peg method, and honestly, it's not THAT bad, but it would be nice to have the extra space to hold stuff with a quad. The retractable tow strap alleviates running it over, and well, the jerk is another story, haha! My thought is to run a...
  8. Busa_Havens

    Towing dragbike

    Good ideas so far. I'd prefer to be a bit further behind the quad also (better viewpoint in case the driver isn't paying attention!). The tiedown with no hook would work "okay" for an emergency like you said, but too many potential issues to make it a regular thing. On previous dragbikes it...
  9. Busa_Havens

    Towing dragbike

    Looking for ideas on how to/where to connect a retractable tow strap to my dragbike. I've been using a pit bike to push in the past, but would like to upgrade to pulling with a quad. I have a couple of ideas, but would like to see if someone has a groundbreaking idea before I continue with my plan.
  10. Busa_Havens

    Neutral LED indicator

    Tried the way mentioned above, didn't work. So I swapped it around and sent switched 12v+ to the LED, tapped into the blue wire for the ground and it works. I'll post pictures of my dash if I can remember to take one!
  11. Busa_Havens

    Neutral LED indicator

    Sounds good. I'll ground the other side of the LED, tap into the blue wire and see what happens!
  12. Busa_Havens

    Neutral LED indicator

    Thanks for the quick replies! I found the GPS plug, but I think I failed in that I unplugged it to test each pin/wire. Unplugged it would have no power, etc. So would the blue wire provide voltage (+) or ground (-)?
  13. Busa_Havens

    Neutral LED indicator

    Looking for some assistance wiring up a neutral indicator light on my Gen II dragbike. No gauge cluster, hence the need for an indicator light. I've searched and searched and haven't found the information I need. Using a 12v led light. Need to know what wire to tap in to. Thanks in advance.
  14. Busa_Havens

    Neutral LED indicator

    Looking for some assistance wiring up a neutral indicator light on my Gen II dragbike. No gauge cluster, hence the need for an indicator light. I've searched and searched and haven't found the information I need. Using a 12v led light. Need to know what wire to tap in to. Thanks in advance.
Back
Top