Recent content by Brett Rahn

Dennis what do you weigh, and how did you get bike to 500lbs, as mine with BST and TI winder is 512

just had it freshened in spring by Bob, and was spotless after 200 plus runs, good oil and keeping it changed helps, Amsoil Dominator 10w30 baby,

guys I raced Saturday at Cecil county raceway and air was at Corrected altitude 805 and Barometer was 29.32 so not killer but good air and I went 8.400 and 8.42 see time slips, how many 300 lb guys on a 500 lb bike can do this on Motor no power adder, stock injectors stock air box ecu tune, I...

Yes I still can bench over 500 best ever was 540 update Doug Witt pro st rider rode my bike at MDIR race last weekend, and he is 180lbs, no set up change in bike so clutch and shock were set up for me not him, and with a shitty 60 ft due to wheelie 1.30 in 60 ft UGH bike still went 8.16 at...

i have 2011 Busa, 18 over Macintosh arm, Penske shock, Catalyst body, BST wheels, front forks done with Slammerz, air shifter, and here comes the one everyone ask what motor!!! a Bob Carpenter 1635!! 9 Mill billet marine stroker crank with Titanium rods, 85mm bore. This baby makes real steam...

give you an idea on that bike I weigh in at 301 in leathers on MIR scale bike weighs in 510 and just went 8.46 on motor! how many 300 lb guys say that

2011 at 18 over with new tail

look at the condor stands great as well

sound like **** look like it to, there are better, TI winder, Muzzy etc, Tsukigi and nogima I believe

I can tell you more and more engine builders like and use Amsoil Dominator race oil, Carpenter, Knecum and Schnitz use them and nothing else, that I know of. I know Rotella is not what it used to be, since government regs on oils they all had to remove most Zinc and Phosphorous, by law for on...

I would use stock oem The idea per Carpenter is what was mentioned above, the unit has a anit back off pin in it, and with idle set up like 1800 rpm to keep good oil pressure to valve train, the stock unit as always will adjust if needed and not back out in any way, my 1630 carpenter motor has...

I have the 24 Volt system on and my 1441 started great, stock main battery a little scooter style in rear, i just charge them with battery tender, 4 years no issue! Now I have 1630 with 18.5 to 1 compression, took stock battery out and replaced it with a Yuasa ytz14 s battery alot better...

Depending on tune, exhaust etc. Thing could run good could be a stone, The head is where its at, You can get over 200hp with stock gen 1 with carpenter head and cam package and pistons, adding 2 mill stroke is good idea but if you dont add anything else for get it. It is a combination of...

get a Carpenter 1441 you wont be sorry there I had one and that is possible the best combo out there, the 1441 i mean, I am sure other builders can do it as well, Carpenter 1441 on pum gas makes around 225-230 depending on pipe etc. I loved it for street use and used stock gen 2 block no issues!

My 1630 Race only package from Bob still has oil cooler and full Rad. Now I was told to use Amsoil Dominator 10w30 oil and engine ice in radiator, I can make 2 runs back to back and coolant never gets above 1/2 way on temp gauge! I ride it on short street rides and again stay cool, so if...