Recent content by Barrocker

Can you change valve seals while the engine is in the bike? 03 Busa

Can you tell me what size tamper proof torx socket for the ignition switch first gen?

Rear shock link would make sense. That's the general area I found it. I'll see if I can find a parts diagram of that. Thanks

Thanks but the washer for that is there and the hole in the center is too small.

I'm doing some work on my 03 Hayabusa and found this washer on the floor. Not sure where it came from. Does anyone recognize it. It is a machined washer or spacer. I replaced the swingarm, front sprocket, clutch pack and springs, rear shock

Gen 1

Also there is a vid on youtube doing it wrong

Awesome thank you

update...just found the washer stuck in the back of the basket. I am getting conflicting info on how to install the two washers. Most say flat washer first then convex one going on next as a concave, high part in. Is that correct

I can see now that the old clutch pack has 2 thick ones. That is obviously what the previous owner did. Thanks for your help

Yes I have the #9 washer but not #10

I am changing my OEM clutch and noticed that the clutch plate wave washer is missing. I have the wave washer seat (convex one). The clutch seemed fine before. It had some mileage on it and since I installed a turbo I wanted to make sure all was top notch. My question is, is it ok to run without...