02BusaMark
Registered
Knew I had until next week for our yearly trip to the gap, and finally got the rear wheel back on the bike. I completed several routine maintenance items and a couple mods. Let's just say I've gotten to know the bike pretty well. No, I didn't install a turbo or check the valve clearance, but I did complete some items that were necessary.
Here is a list of items that were completed:
In the fall
-Replacement mirrors and added mirror extenders
-Repainted side fairings
-Replacement stator cover
-Replacement clutch lever
-Recharged/oiled air filter
-replacement hi beam bulb
In the winter
-Replacement shifter spring
-Replacement shifter gasket
-Radiator flush and fill
-Oil filter/oil change
-2nd power outlet
-Trunk mod
-Replacement rear turn signals
-Replacement license plate bulb
-Replacement wind screen
-Replacement Cush drive rubbers
-New rear tire
-Chain lube/adjustment
-Horn upgrade
-Replacement push pins
-Adjusted headlights
The only items not completed by me was the painting for the fairings (dropped off for a local paint guy) and the actual tire change from the wheel (took them the wheel and they changed the tire). I'm by no means a grease monkey, but I've gotten a little bit more proficient at turning a wrench. Everything that was on my to-do list is now complete. Will probably replace the pads sometime this summer, but I'm in pretty good shape right now. Just ready to get out and do some riding!
Here is a list of items that were completed:
In the fall
-Replacement mirrors and added mirror extenders
-Repainted side fairings
-Replacement stator cover
-Replacement clutch lever
-Recharged/oiled air filter
-replacement hi beam bulb
In the winter
-Replacement shifter spring
-Replacement shifter gasket
-Radiator flush and fill
-Oil filter/oil change
-2nd power outlet
-Trunk mod
-Replacement rear turn signals
-Replacement license plate bulb
-Replacement wind screen
-Replacement Cush drive rubbers
-New rear tire
-Chain lube/adjustment
-Horn upgrade
-Replacement push pins
-Adjusted headlights
The only items not completed by me was the painting for the fairings (dropped off for a local paint guy) and the actual tire change from the wheel (took them the wheel and they changed the tire). I'm by no means a grease monkey, but I've gotten a little bit more proficient at turning a wrench. Everything that was on my to-do list is now complete. Will probably replace the pads sometime this summer, but I'm in pretty good shape right now. Just ready to get out and do some riding!
