i've had my puig db windscreen on for a few weeks now. Was lookin at it recently and noticed there was about a 1/4" gap at the very bottom of the windsreen where it meets the nose of the bike, looked like it wasn't pushed down far enough. So i took the 2 bolts out by the mirrors and pushed the windscreen down and it popped into place like it should be. After that i noticed it put a hairline crack/crease in the plastic nose about 3" above the headlight, wtf! It is only about an inch wide, didn't actually crack the paint but u can see a little crease in the plastic, put a sticker over it so it's not noticeable. Should have just left it alone. It's like it's too tight of a fit up front and just put too much stress on the plastic when i pushed it down more. Wonder if anyone else runnin the puig had this happen, i highly doubt it