fuel guage reading 140 psi

[Hit Man]

Does anyone have any theories on why my fuel guage is showing 140psi @ 5#s of boost.I just replaced a few vacuum hoses that were cracked.The boost will not get higher than 5#s, normal boost is 8#s on the wastegate. I disconnected the boost controller and saw no changes.

[suzuki4life]

Originally Posted by Hit Man

Does anyone have any theories on why my fuel guage is showing 140psi @ 5#s of boost.I just replaced a few vacuum hoses that were cracked.The boost will not get higher than 5#s, normal boost is 8#s on the wastegate. I disconnected the boost controller and saw no changes.

gauge is screwed up?

[Hit Man]

I'll try another one.I rebuilt my fmu 2 weeks ago.

[suzuki4life]

My gixxer kit had old dry rotted lines...I replaced them and gained back 5 psi. But you are talking 50+ psi

I would guess a faulty gauge.

[turbobusa2000]

What have you changed lately, just the vacuum lines?

[Hit Man]

I changed the lines and reconnected the wastegate line, I disconnected the boost controller, and checked the throttlebodies for leaks or open connections.The lines have been on since Feb. '08.

[OZBooster]

What is it running like, real 140 psi fuel pressure would run like s hit

[Hit Man]

Its running nornal until I give it full throttle, but the guage shows the rise climbing faster than normal.On full throttle it runs crappy like its loosing boost or running too rich to pull cleanly through the rpms.

[turbobusa2000]

My guess is you need to readjust your pressure regulator. Apparently something changed when you replaced those lines.

[The Big Red One]

Originally Posted by Hit Man

I'll try another one.I rebuilt my fmu 2 weeks ago.

I'd doublecheck the FMU rebuild

[OZBooster]

Yep check your vac lines and make sure the needle valve is in its original position,

[kawiboy11]

Damn FMU's!

[Hit Man]

I noticed the return line on the fmu collapsed 2" before the tank. When I bolt the tank down, the line would twist and pinch off the path for fuel to return, therefore raising pressure through the roof. The shims in the fmu did not crack because the pressure was never applied to them. All of this came from yet another dry rotted line.

[2wicked]

Originally Posted by Hit Man

I noticed the return line on the fmu collapsed 2" before the tank. When I bolt the tank down, the line would twist and pinch off the path for fuel to return, therefore raising pressure through the roof. The shims in the fmu did not crack because the pressure was never applied to them. All of this came from yet another dry rotted line.

If your fuel system had 140 psi in it then the shims did see the pressure, even though it was not the FMU raising the pressure it was still subjected to the pressure, check the shims just to be sure,

Richard

[Hit Man]

I checked the shims again today and they looked good. Thanks for the input.

[turbobusa2000]

So whats happened. Have you figured it out. Did you try readjusting the FMU.