Turbo fuel problem

[mdelaven]

Hi all I need some help. Just installed a turbo stage 1 on 05 busa everything looks good new fuel pump,15amp fuse, powercommander eveything ready. Went for a start fuel pump gage 48psi starts right up runs 10 sec and dies. Turn key off and back on pressure 48psi starts backup dies turn key off again and back on no fuel pump off again back on nothing wait for 10min back on pressure back to 48psi starts up runs then dies this time I see the powercommander goes blank before bike dies. How can I tell if powercommander is working right or has a problem? Any ideas?
Thanks Mike

 

[suzuki4life]

my first guess would be to swap in another power commander. Maybe you are losing power or ground? If the ecu loses power the bike will shut down immediately.

 

[cdhoroho]

try it without the PC if it still does it then its not the PC

 

[mdelaven]

Thanks for your help.
Found out what it was it was the tip over sensor going bad
Mike

 

[magus]

your fuel pressure is a bit high should be around 43 psi may want to adjust your fmu down a bit at idle