Removing Balancer

[OB_GSXRboy]

I read all the topics on removing the balancer and decided to remove mine. My question is how and what do I have to do so I can remove it? Any help/tips would be great!

 

[OB_GSXRboy]

Come on someone has to know how to do this and what to watch for???

 

[OB_GSXRboy]

OK, then are there any shops here in Michigan that want to remove it??? I thought these boards were for everyone to discuss secrets of the Hayabusa and what they have been doing?? So should I not help out and respond to people when they need help, just ask them to bring me their bike and I'll do it for $300???

 

[OB_THE MOTORHEAD]

use the search engine.these are old topics discussed many times

 

[OB_GSXRboy]

I did and everyone talked about it but never talked about how to remove it or what to be carefull of....

 

[OB_GSXRboy]

I've seen a few post about removing your balancer, someone had to do it???

 

[OB_GSX1360R]

The reason you're not getting replies is because shops depend on secrets like this to stay ahead of the competition. It will cost you about $350 to $500 in most shops to have it done. Don't expect big HP. gains either.

 

[OB_THE MOTORHEAD]

a lot less if you do the pipe at the same time

 

[OB_THE MOTORHEAD]

make sure to seal off oil and that oil cannot leak arond where shaft butts up inside the case at shafts end.oil pan and a exh and a few oil lines is all that you remove to access and remove it.seal all the oil holes that use to lube it's bearings!

[This message has been edited by THE MOTORHEAD (edited 14 March 2000).]

[This message has been edited by THE MOTORHEAD (edited 14 March 2000).]