Rear Wheel Bearing Spacer Length?

jpbusa900

Registered
Hi this is my first post here, after changing the rear bearings on the new bike I've noticed that the spacer that's supposed to be between then is missing, I want to make a new one on the lathe but wanted to ask here if anyone knew the length of it? I've roughly measured and I think it's 121mm from bearing seat to seat but wanted to see if anyone on here knew for certain or could measure one?
Thanks
 
Hi this is my first post here,
after changing the rear bearings on the new bike .

I've noticed that the spacer that's supposed to be between then is missing,
I want to make a new one on the lathe but wanted to ask here if anyone knew the length of it?

I've roughly measured and I think it's 121mm from bearing seat to seat but wanted to see if anyone on here knew for certain or could measure one?

Thanks .

http://rover.ebay.com/rover/1/711-5...0001&campid=5337943218&icep_item=272379089202

s-l1600.jpg
 
Pretty sure there is supposed to be a bit of a "AIR GAP" between the Bearing and the Spacer on one side, it is not supposed to be "pressed till it bottoms"
 
Back
Top