Pair valve suggestion..easy

[MTRHD101]

Why wouldn't it work just as well on the pair valve mod/removal  to just remove the valve, put longer pieces of hose on the bottom of the tubes where they use to connect to the valve, and just connect them to each other, then you have isolated the tubes without even having to remove them.. Install 2 vacuum caps on and your done..  Instead of buying a kit and removing all the tubes..

 

[vincebusa]

I am sure it would work.But why go though all that trouble
if you can remove the whole thing and save your self pound or two.I did mine when i installed my full system.

<!--EDIT|vincebusa
Reason for Edit: None given...|1104109276 -->

 

[Charlesbusa]

Less weight with block off plates, if that matters to you.  Otherwise, capping the lines would seem to work also.



<!--EDIT|Charlesbusa
Reason for Edit: None given...|1104110462 -->

 

[MTRHD101]

You would remove the valve, and leave the tubes only.. I doubt they weigh 6 ounces.. About the difference of having your wallet in your pocket or not..