Gen II OEM parts guide/torque spec/wrench guide

Since the cold will be coming, I've been reading up on heated...whatevers...as in heated gloves, grips, clothing, etc.
Apparently, a minimum charging system output can be required in some instances to have enough juice to run your gear. 250 Watts seems to be the threshold based off the attached Gerbing review from Webbike World (this was the only such reference I found where output could cause a problem, but it did have me wondering). The Gen II is more than capable of safely running this type gear (based off my reading) Heated Motorcycle Jacket Liner - webBikeWorld. I did not see the charging system output listed and had to go to the manual...Section 1J-15


Gen II generator output - 400 Watts max @ 5,000r/min...more than enough based off the reading I've been doing.

:thumbsup:
 
Last edited:
Turnsignals
OEM LAMP REAR RH 35603-15H00
OEM LAMP REAR LH 35604-15H00
OEM BULB 09471-12186
OEM LAMP FRONT RH 35601-15H00
OEM LAMP FRONT LH 35602-15H00
OEM BULB 09471-12186

Bulb type is PY21W. The pins are slightly offset (ie not 180 degrees apart)
 
AMSOil SMF 109
Bike Master 314-0025
Champion PH7016
Cycle Power 314-1919
Emgo 10-55662
Emgo 10-55660
Fram PH6018
Hi-Flo HF138
J.C.Whitney ZX063166P
K&N 138
K&P Engineering - S2 (Re-usable)
NAPA 1359 / WIX 51359
NAPA PS7937
Parts Unlimited
Per-Form J-509
ProPart 01-0029
Purolator ML16818
Scotts Performance Reusable - #17255
STP SMO-18
Suzuki 16510-03G00-X07
VESRAH vsf-3009
WIX 57937
 
Torque specs?

Steering head bolt? The one we remove to put a steering dampner on like a GPR or Scott's
 
the wireing diagram linked to is for a gen 1. no secondary tps, or secondary throttle blades on it and only one set of injectors.

I found a link to the factory service manual that is supposed to be stickied, but can not access it. says I do not have posting privliges. Post count not high enough?

Hooking up a wideband commander 2 and need to know tps wires. assuming the same as a 05-06 gsxr 1000 and from memory the pink wire with black stripe is the voltage out and black wire brown stripe is ground. red wire is 5v to sensor.

white wire with blue strip taped into at ecu for rpm.

any one have a link for a 08-09 busa service manual?
 
the wireing diagram linked to is for a gen 1. no secondary tps, or secondary throttle blades on it and only one set of injectors.

I found a link to the factory service manual that is supposed to be stickied......?

Fixed to reflect its GEN I
looking for a GEN II but not having any luck
 
Nice thread thanks.

I just got lowering links. I'm not sure what the stock part is called but, what would be the torque for that? I tried clicking on the "Shop Manual (Gen2)" link but it told me I didn't have access to it. Thanks.
 
Last edited:
I can't access the k8 shop manual for some reason. I used to have it dl'ed from this site but i have lost it due to os re-installs, if an admin could help me i would appreciate it.
 
Back
Top