Fuzeblock for Hayabusa

Discussion in 'PashnitBusa.com' started by pashnit, May 7, 2015.


  1. pashnit

    pashnit Site Sponsor Registered

    Contests won:
    0
    Name:
    Tim
    Wiring project for your Hayabusa - then you need a Fuzeblock.

    Helps isolate your project from the bikes electrics. And you can source your hot wire from the battery direct, or through the ignition.

    Buy Now: http://www.pashnit.com/product/fuzeblocks/index_fuzeblocks.html#top

    • Weather Resistant Cover
    • Flame retardant ( UL 94-5VA ) ABS Cover
    • 2 - Onboard diodes to prevent transient voltages (Good news for Canbus bikes)
    • Each circuit can handle up to 10A
    • The total amperage used via the relay (switched power) is 30A
    • Note: The total amperage for the entire FZ-1 should not exceed 30A
    • Crimpless heavy duty screw terminals
    • Wiring gauges up to 12AWG
    • Mini ATM fuses that can be found at most auto parts stores
    • Spare Fuse holders
    • Dimensions: L 3.25" x W 2.5" x H 1.25"

    7426155082_bf261b0410_b.jpg

    7426155192_cec00747a7_b.jpg

    7506553304_5154468142_b.jpg


    I made my own wire harness, but we also offer that too!

    7426159070_cc3a1cc734_b.jpg
     
  2. pashnit

    pashnit Site Sponsor Registered

    Contests won:
    0
    Name:
    Tim
  3. fallenarch

    fallenarch I made fun of the panties, now I have them :( Registered

    Contests won:
    0
    Name:
    Willie Cooper
    I don't have the Pashnit one but the fuse block is awesome guys & girls. Makes wiring a snap - no more hunting for a power source that's switched or unswitched and cutting into OEM wiring harnesses. Also you can control fusing better so you don't fry an expensive accessory because it was tapped into too much power. For touring guys and bike night blinggers this is a must!
     

Share This Page