clutch spring bolts?

Discussion in 'General Bike Related Topics' started by XZZR1200, Mar 14, 2009.

  1. XZZR1200

    XZZR1200 Registered

    anyone around northern Illinois have a torque wrench that goes down to 7ft. lbs. that I could borrow?? I changed my clutch and need to tighten the spring bolts and my wrench only goes to 20 lbs. Or any suggestions would be appreciated. Thanks
     
  2. 1BDAZM

    1BDAZM Registered

    Sears
     
  3. roadthing

    roadthing Warren D. is my co-pilot Donating Member

    You could always grab an inch-pound wrench and set it for 84 inches. It would actually be a little more precise that way. If anyone you know has one of those, you are good to go.

    If not, +1 on 1BDAZM's suggestion of Sears :thumbsup:
     
  4. djsin

    djsin Lily's Daddy Registered

    I think I have an inch pound wrench but im in northern Indiana....about 83 miles from the border down 80/90
     
  5. Gixx1300R

    Gixx1300R Registered

    Make damn sure you apply loctite blue to the bolts.
     

Share This Page