Cam Setup

HotFoot

Red Light! Yes!!
Donating Member
Registered
is this correct
P1010016a.jpg

P1010016a.jpg
 
PS - make sure you reinstall the journal holders and cam chain guide BEFORE you cut those zip ties. :banghead:
 
may be perfect bu then again i dont see a picture of the bottom of the chain and its markings
 
Hey Guys Just a quick question
in the book
It said that the cam bolts all have a number 9 on them
I only have 4 bolts that have a number 9
and I put them on were the bearings are right behind the
cam sprockets

am I missing something or is all good

Thanks
Kevin
 
Thanks John
It must be right
because I have the motor all together a no extra bolts hangen around
with a number 9 on them :beerchug::thumbsup:
 
Make sure the crank is at Top Dead Center & be sure the cam bearing is in the locater groove. Otherwise the alignment shown is correct.
 
Back
Top