Discussion in 'Busa Mods' started by reiecco, Jun 9, 2017.
Starting a thread per my progress since starting on her
In the beginning
By By ABS
Spoke to Mike today at PPM Custome Cycles. Sent him pictures of what I thought his company made a few years ago and he said the AAA swingarm kit I have went for $4,700 dollars...Hell yeah!
ordered the axle adjuster covers 2day.
Well, Spiegler sent me the wrong line made 12 inches over. They sent me a line from ABS manifold to master cylinder, made 12 inches over. That was a major screwup. So, last night I tried to make it fit anyway, seeing as how I wanted to get something done. So, I did a roundabout then a loop and installed it. Called them this morning and they're sending out the correct one from ABS manifold to the rear caliper. Here are some pics of the incorrect one that I installed.
On another note, I did get the bike to run last night after about five hours of electrical work.
if you ever want to sell that swing arm and wheel ( its not on AAA's site)
ha ha...yeah I found this out as well. Come to find out, it is chrome molly as well
Brakes work, to my surprise, it only took about 5 minutes to bleed the system. I rather the new speaker rear brake line underneath the 12 inch over swingarm 95% of the way. Drilled some holes underneath and used plastic keepers in the holes with stainless steel screws and heavy duty nylon circles to keep it in place.
I'm a photo whore, so I don't hope you all don't mind all the photos