I am starting to take apart the 1970 camaro and working on it piece by piece.
Other than taking it down and having someone sand blast it, what is another way I can remove the paint from the vehicle? (outside, inside, engine compartment, trunk, everywhere)
I tried using a sanding wheel. I don’t think that is going to cut it.
I remember seeing some kind of paint stripper you put on a drill, not sure how well they work or where to get one.
I have also used Naval Jelly which is a liquid, that seemed to work well on rust, not sure how it would work as far as dissolving paint and what kind of mess it would make.
Just not sure which way to go at this point. I need to be able to get into a lot of the cracks and crevices including taking the hood off and stripping the underside of all paint.
Anyone have any advice?
Other than taking it down and having someone sand blast it, what is another way I can remove the paint from the vehicle? (outside, inside, engine compartment, trunk, everywhere)
I tried using a sanding wheel. I don’t think that is going to cut it.
I remember seeing some kind of paint stripper you put on a drill, not sure how well they work or where to get one.
I have also used Naval Jelly which is a liquid, that seemed to work well on rust, not sure how it would work as far as dissolving paint and what kind of mess it would make.
Just not sure which way to go at this point. I need to be able to get into a lot of the cracks and crevices including taking the hood off and stripping the underside of all paint.
Anyone have any advice?