Aux pwr for all accessories how too .

c10

Registered
I see many motorcycles with random elect mods that are usually thrown on last minute , and butchered . Later they work lose leaving the item not working , causing a short , blowing fuses , leaving rider stranded , or even burning the bike to the ground .
I did not do my busa till today due to shori battery had two mounting holes , but they were pilling up . So I installed a single terminal strip with one fused 12 gauge wire . then jump the pwr to 5 more terminals . Same to the ground side marked in black . Now its a easy wire in/out for any
pwr accessory. I'm also using a LARGE battery that required removal of seat pan . Total time 2 hours at a slow pace , materials $35 if you have no parts around . ( free if your a elect guy like me )

20151019_162259_zpskaejkxbb.jpg
20151019_171317_zpsdxe3us44.jpg
20151019_172202_zpsxnq3a12m.jpg
20151019_174644_zpsfg30jumt.jpg
20151019_174653_zps6risplc4.jpg
20151019_174703_zpssyvevsry.jpg
20151019_174736_zpsbfsef2on.jpg
20151019_174948_zpszutesjtz.jpg
20151019_175911_zpswhnadwvr.jpg
20151019_175951_zpscr1ldgrf.jpg
20151019_180150_zpssq83dpos.jpg

I also store EZ toll tag , plugs , and plug tools here for more room in tail section .
Make the most of your space :)
 
Last edited by a moderator:
Important to have a relay in the loop somewhere or your accessories will wear the battery down if you fail to turn them off. This is what I did; the entire fuse block is powered by a single relay.


P1080689_zps12293680.jpg
 
Last edited by a moderator:
A step by step DIY would be appreciated.

Don't seem like a job for a newbie to electricals....but very impressive indeed...
 
I see many motorcycles with random elect mods that are usually thrown on last minute , and butchered . Later they work lose leaving the item not working , causing a short , blowing fuses , leaving rider stranded , or even burning the bike to the ground .
I did not do my busa till today due to shori battery had two mounting holes , but they were pilling up . So I installed a single terminal strip with one fused 12 gauge wire . then jump the pwr to 5 more terminals . Same to the ground side marked in black . Now its a easy wire in/out for any
pwr accessory. I'm also using a LARGE battery that required removal of seat pan . Total time 2 hours at a slow pace , materials $35 if you have no parts around . ( free if your a elect guy like me )

View attachment 401790
View attachment 401791
View attachment 401792
View attachment 401793
View attachment 401794
View attachment 401795
View attachment 401796
View attachment 401797
View attachment 401798
View attachment 401799
View attachment 401800

I also store EZ toll tag , plugs , and plug tools here for more room in tail section .
Make the most of your space :)
step-by-step?
 
Back
Top